Knowledgebase
Maestro Wireless Solutions > Support - Maestro Wireless Solutions > Knowledgebase

Search help:


Activate 5Hz mode on SSIV based modules

Solution

Since firmware 4.1.0 SSIV based modules (A2xxx: A2100, A2035, etc.) can issue NMEA trames at a rate of 5Hz instead of 1Hz before.

The 5Hz mode works as a rate multiplier for the value you set in the NMEA rate. For example, if you set a message to refresh every 1s in normal mode, in 5Hz mode it will refresh every 1/5 seconds. Set to every 5 seconds in normal mode of time will give 5/5 = one message per second in 5Hz mode.

Here are some commands to send to activate this mode. Refer to the NMEA and OSP manuals for details about the parameters and change them as needed for your application:

Procedure to activate: NMEA and OSP Modes

1. NMEA command MID103 ($PSRF103,00,6,00,0*23)
2. OSP command MID136 (A0 A2 00 0E 88 00 00 04 04 00 00 00 00 00 00 00 0F 02 00 A1 B0 B3 )

Note that the 5Hz mode works only in navigation mode, once a GPS fix has been obtained. Until it gets a fix, the receiver will work in 1Hz mode.

 
Was this article helpful? yes / no
Related articles Patch Upgrade
From Data Mode to Command Mode
A5100-A Outputting in GNRMC instead of GPRMC
SmartPack Automatic connection APP NOTE
How to reset your modem configuration to default
Article details
Article ID: 4
Category: GPS Module
Date added: 2012-03-06 19:00:26
Views: 1742
Rating (Votes): Article rated 4.2/5.0 (10)

 
« Go back

 
Powered by Help Desk Software HESK, brought to you by SysAid