Knowledgebase
Maestro Wireless Solutions > Support - Maestro Wireless Solutions > Knowledgebase

Search help:


Use WAN as LAN2 on E220/E200 Device

Solution

Firmware Requirement: v2.2.0 RC8 and above

Please follow the procedure mentioned below in order to make the WAN port work as LAN2:

Network > Load balancing > Configuration > Interfaces > Delete WAN > Save and Apply
Network > Load balancing > Configuration > Members > Delete WAN > Save and Apply
Network > Interfaces > Edit WAN > Protocol > Unmanaged > Switch Protocol > Save and Apply
Network > Firewall > Zones > WAN to LAN > Tick Masquerading and MSS > Save and Apply
Network > Interfaces > Edit LAN > Physical Settings > Tick WAN eth value > Save and Apply
 
Was this article helpful? yes / no
Related articles (LUCI) Port forwarding overview E200 series routers
Activating the Verizon M100 CMDA485 and CDMAPlus (not pulling IP)
Article details
Article ID: 67
Category: Router
Date added: 2017-03-23 21:05:04
Views: 346
Rating (Votes): Article rated 3.4/5.0 (20)

 
« Go back

 
Powered by Help Desk Software HESK, brought to you by SysAid