Maestro Wireless Solutions
            Knowledge Base Maestro Wireless Solutions Modems

            How to upgrade/reinstall SmartPack

             (You may use the terminal program of your choice, or download TeraTerm*)

            Command: ATI3 (Verifies current firmware version)

            Example: R7.53.0.A3.201501301110.SL3010T Rev 1.0 1852436 013015 11:10

            Command: AT+WOPEN=0 (Modem will disconnect and reboot, reconnect via Tera Term**)

            Command: AT+WOPEN=3 (Erases SmartPack settings, modem should respond with OK, but might error out if you are following this entire document no problem**)

            Command: AT+WOPEN=4 (Erases the complete application, modem will disconnect and reboot**)

            Command: AT+WDWL (Triggers Downloader)

            Wait for the following to display: +WDWL: 0 (Modem will disconnect and reboot**)

             

            In TeraTerm go to: File > Transfer > X-modem in (Check the 1K radio box) then send the file: 

            M100CDMAplus_SmartPack_v22_SL3010T_R753_160316.dwl

            After file is sent, reboot the modem with command: AT+CFUN=1**

            After modem reboot and reconnect, run command: AT+WOPEN=1 (This opens the application, modem will reboot again**)

            Verify correct version of SmartPack with command: AT+VAFV it should now read:

            Example: M100CDMAplus_SMARTPACK_v22_SL3010T_R753_160316

             

            WARNING: This will wipe out any current configuration. You will need to reconfigure custom settings

            *Download resources:

            TeraTerm= http://download.cnet.com/Tera-Term/3000-20432_4-75766675.html

            SmartPack For M100CDMA=http://update.maestro-wireless.com/M100/m100cdmaplus/ 

            SmartPack For M1003G=http://update.maestro-wireless.com/M100/m1003g/

            (Use the SmartPack version that corresponds with your firmware, example: SmartPack_v22_SL3010T_R753_160316.dwl for 7.53.) 

             

            **Reconnecting quickly with TeraTerm:

            Disconnect COM port (Shortcut ALT+I, ENTER)

            Re-open the COM port (Shortcut ALT+N, ENTER)


            Updated: 02 Oct 2018 06:00 PM
            Helpful?  
            Help us to make this article better
            0 0